ProForm 395 E Elliptical English Manual - Page 9

7. The Console (4) can use four D batteries (not included); alkaline batteries are recommended. 7 Do not use old and new batteries together or alkaline, standard, and rechargeable batter- ies together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic com- ponents. Remove the battery covers from the back of the Console, and insert batteries into the battery compartments. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. Then, reattach the battery covers. To purchase an optional power adapter, call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power adapter. Plug one end of the power adapter into the receptacle inside the battery compartment on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. 8. Untie and discard the wire tie on the Main Wire (42). 8 While a second person holds the Console (4) near the Upright (2), connect the wires on the Console to the Main Wire (42) and to the Sensor Wires (28). Insert the excess wire into the Upright (2) or into the Console (4). Tip: Avoid pinching the wires. Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (53). Battery Cover 4 Battery Cover Receptacle 4 Avoid pinching the wires 42 2 28 53 9. Orient the Rear Console Cover (81) as shown. 9 Have a second person hold the Rear Console Cover (81) against the Upright (2) until you complete step 10. 81 2 9