ProForm 420 Ce Elliptical English Manual - Page 10

8. Identify the Right Handlebar (10) and orient it as shown. 8 Have a second person hold the Right Handlebar (10) near the right side of the Upright (5). Locate the indicated wire tie in the Upright (5). Tie the lower end of the wire tie to the Pulse Wire (34) inside the Right Handlebar (10). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Avoid pinching the Pulse Wire (34). Attach the Right Handlebar (10) to the Upright (5) with two M8 x 16mm Screws (102) and two M8 Split Washers (103). Attach the Left Handlebar (11) in the same way. Avoid pinching the Pulse Wire (34) 11 Wire Tie 34 5 10 103 102 9. Untie and discard the wire tie (not shown) on the Wire Harness (60). 9 33 While a second person holds the Console (33) near the Upright (5), connect the wires on the Console to the Wire Harness (60) and to the Pulse Wires (34). Insert the excess wire into the Upright (5) or into the Console (33). Tip: Avoid pinching the wires. Attach the Console (33) to the Upright (5) with four M4 x 16mm Screws (93). Avoid pinching the wires 34 5 60 93 10