ProForm 500i Treadmill User Manual - Page 9
Cover the Upright Wire 42 with the Right Grip Plate - walking belt
View all ProForm 500i Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
8. Cover the Upright Wire (42) with the Right Grip Plate 8 (36). Be careful not to pinch the Upright Wire. Tighten three 1/2" Screws (48) into the Right Grip Plate and the Console Base (47). 47 42 36 48 9. Attach the Latch Housing (29) to the left Upright (69) with two 3/4" Screws (2). Make sure that the large hole in the Latch Housing is on the side shown. Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Then, insert the pin into the Latch Housing (29), and tighten the knob back onto the pin. 9 Knob 2 29 Spring 69 Large Hole Collar Pin 10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill. 9