ProForm 510 Uk Manual - Page 5

ASSEMBLY Before beginning assembly, carefully read the following information and instructions: • Assembly requires two people. • Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. • As you assemble the treadmill, be sure that all parts are oriented as shown in the drawings. • Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, wipe off the lubricant with a soft cloth and a mild, nonabrasive cleaner. The following tools (not included) are required for assembly: • two (2) adjustable spanners • one (1) phillips screwdriver If further assistance is needed, please call our Customer Service Department at 08457 089 009. 1. Refer to drawing 2 below. Note that the Console 1 (49) is connected to the right Upright (37) by the Wire Harness (53). During assembly steps 1-3, be careful to avoid damaging the Wire Harness. With the help of a second person, carefully lay the treadmill on its side. Position one of the Base Legs 37 (55) on the base of the Uprights (37) as shown. Make sure that the Base Leg Pads (31) and the Wheel (34) are in the indicated positions. Attach the Base Leg with two of the four Base Leg Bolts (28), Base Leg Washers (68), and Base Leg Nuts (61). Carefully turn the treadmill onto its other side. Assemble the other Base Leg (55) as described. With the help of a second person, carefully raise the treadmill to the upright position so the Base Legs (55) are resting flat on the floor. 2. Hold the treadmill firmly with both hands, and lower 2 the treadmill to the floor. To decrease the possibili- ty of injury, bend your legs and keep your back straight. 34 61 28 68 31 55 49 53 37 5