ProForm 510e Uk Manual - Page 8

7. Connect the Extension Wire (2) to the corresponding wire on the Console (6). Next, connect the ground wire to the indicated hole in the Upright (3) with an M4 x 16mm Screw (34). Carefully feed the wires down into the Upright (3). Attach the Console Base (14) to the Upright with four M4 x 16mm Screws (34). Be careful to avoid pinching the wires. 7 Console Wires 6 14 34 2 Ground Wire 34 8. Find the Left Pedal (31), which has a ridge on the right side. Attach the Left Pedal to one of the Pedal Arms (12) with three M4 x 19mm Flange Screws (16) as shown. Repeat this step to attach the Right Pedal to the other Pedal Arm (not shown). 34 3 8 16 9. Identify the Left Handlebar (8) (there is an "L" sticker on the Left Handlebar). Apply a thin film of the included grease to the axle on the Left Handlebar. Make sure that there are two Pedal Arm Bushings (11) in each Pedal Arm (12). Slide a Handlebar Spacer (39) and the Pedal Arm (12) with the Left Pedal (31) onto the Left Handlebar (8) as shown. (Note: These parts fit tightly; it may be helpful to use the rubber mallet.) Next, tap a 3/4" Axle Cap (43) onto the Left Handlebar. Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (62). 9 8 39 11 43 12 31 Ridge 31 12 62 12 Apply Grease 8