ProForm 530 Zlt Instruction Manual - Page 8

2. Make sure that the power cord is unplugged. 2 Remove and discard the two screws (A) and the shipping bracket (B) on the right side of the Base (74). Then, remove and discard the screws and the shipping bracket (not shown) on the left side of the Base. Next, remove the tie securing the Upright Wire (63). Then, press a Base Cap (70) into each side of the Base (74). B 74 A 3. Identify the Right Upright (76). Have a second person hold the Right Upright near the Base 3 (74). Wire 63 Tie See the inset drawing. Tie the wire tie in the Right Upright (76) securely around the end of the Upright Wire (63). Then, insert the Upright Wire into the lower end of the Right Upright as you pull the other end of the wire tie out of the top of 76 the Right Upright. Tie 63 70 63 Wire Tie 76 74 8