ProForm 530 User Manual - Page 7

2. Attach a Wheel (108) to each Wheel Housing (106) with a Wheel Bolt (107) and Wheel Nut (21). Make sure that the Wheel Bolts are inserted from the sides shown. Do not overtighten the Wheel Bolts. 2 107 106 21 106 108 107 3. Press the two Base Endcaps (99) (only one is shown) into the Base (109). Make sure that the angle of each Base Endcap matches the angle of the Base, as shown in the inset drawing. Insert a Wheel Housing (106) into the Base (109). Make sure that the Wheel Bolt (107) is on the side shown. Insert the other Wheel Housing (not shown) in the same way. Attach the four Base Pads (100) (only two are shown) to the bottom of the Base (109) with eight 3/4" Tek Screws (47). Note: There are no screw holes in the Base Endcaps (99). Press firmly on the screwdriver when tightening the Tek Screws. With the help of a second person, carefully tip the treadmill so the four Base Pads (100) are resting on the floor. 4. Identify the left handrail, which has a hole in the indicated location, and the right handrail. Hold the right handrail near the Right Upright (82). Insert the Wire Harness (83) into the large hole in the right handrail and out of the upper end as shown. Next, hold the right handrail against the Right Upright (82), and hand tighten two 5/16" x 1" Bolts (122) into the upper end of the right handrail and the Right Upright. Be careful not to drop the Bolts into the handrail. Tighten a 4" Bolt (112) into the Right Upright and the lower end of the right handrail. Firmly tighten all three Bolts. Attach the left handrail to the Left Upright (81)as described above. Note: There is not a wire harness in the Left Upright. Press two Upright Endcaps (69) into the upper ends of the Uprights (81, 82). Make sure that the notches in the Upright Endcaps are up as shown. 3 107 106 109 99 100 47 100 47 21 109 99 4 122 Left Handrail Notch 69 Hole 81 122 Right 112 Handrail 83 Notch 69 82 112 7