ProForm 620 Zlt Treadmill Uk Manual - Page 7

ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • To identify small parts, see page 6. • Assembly requires the following tools: the included hex keys one Phillips screwdriver scissors • To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Remove and discard the two screws (A) and the shipping bracket (B) from the right side of the Base (74). Then, remove and discard the screws and shipping bracket (not shown) from the left side of the Base. B 2. Locate the Upright Wire (63) bundled around the front of the Base (74). Cut the plastic tie securing 2 the Upright Wire. Pull the end of the Upright Wire out of the indicated hole. See the inset drawing. Cut the plastic tie near the Upright Wire (63). Be careful not to damage the Upright Wire. A 74 74 Hole Cut 63 Tie Cut 63 7