ProForm 635cw English Manual - Page 7

4. Slide the upper end of a Handrail (85) and then the Extension Leg (103) into the right Upright (82) as shown. 4 85 (Note: It may be helpful to tip the Uprights [82] forward 85 as you insert the Extension Leg. If necessary, tap the Extension Leg with a rubber mallet to fully insert it.) Slide the other Handrail (85) into the left Upright (82) as 82 described above. 82 5. With the help of a second person, carefully tip the Uprights (82) down as shown. Make sure that the Extension Legs (103) and Handrails (85) remain in the Uprights. Attach each Extension Leg (103) with two Short Screws (101) as shown. You may need to press down or tap on the top of the Uprights (82) with a rubber mallet to fully insert the Extension Legs. Tighten the Handrail Bolts (78). Note: One replacement Base Pad (97) may be included. Use the extra Base Pad if one becomes worn or needs to be replaced. With the help of a second person, carefully tip the Uprights (82) back to the upright position. 6. Refer to drawing 6a. Locate the left Rear Foot (59) on the treadmill. If the left Rear Foot touches the floor, go to step 7. If there is a space between the left Rear Foot and the floor, follow the instructions below. Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 18. Refer to drawing 6b. Using a phillips screwdriver, remove the Screw (60), the right Rear Foot (59), and the Rear Foot Spacer (114) from the treadmill. Reattach the right Rear Foot without the Rear Foot Spacer. Hold the treadmill with both hands, and lower the treadmill as described on page 18. Check the left Rear Foot (59 [see drawing 6a]). If the left Rear Foot is still off the floor, raise the treadmill and remove the left Rear Foot. Snap the Rear Foot Spacer (114) onto the left Rear Foot and reattach the left Rear Foot. Carefully lower the treadmill. 103 5 97 82 85 103 6a 85 101 78 97 82 101 103 78 97 59 6b 60 59 114 7. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet from damage, place a mat under the treadmill.