ProForm 650 Crosstrainer Treadmill English Manual - Page 13
Formation Mode/demo Mode
View all ProForm 650 Crosstrainer Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
The left side of the display will show the elapsed time, the distance that you have walked or run, and the incline level of the treadmill. Note: When a program is selected, the display will show the time remaining in the program instead of the elapsed time. The right side of the display will show the approximate number of calories you have burned while walking or running, the speed of the walking belt, and your pace in minutes per mile. The right side of the display will also show your heart rate when you use the handgrip pulse sensor or the optional chest pulse sensor. Note: The console can display speed and distance in either miles or kilometers. To find out which unit of measurement is selected or to change the unit of measurement, see THE INFORMATION MODE/DEMO MODE on page 16. Note: For simplicity, all instructions in this section refer to miles. To reset the display, press the Stop button, remove the key, and then reinsert the key. 6 Measure your heart rate if desired. Note: If you use the handgrip pulse sensor and the optional chest pulse sensor at the same time, the console will not display your heart rate accurately. Before using the handgrip pulse sen- sor, remove the sheets of clear plastic from the Contacts metal con- tacts. In ad- dition, make sure that your hands are clean. To measure your heart rate, stand on the foot rails and hold the metal contacts on the handrail-avoid moving your hands. When your pulse is detected, one or two dashes will appear in the right side of the display and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 7 Turn on the fan if desired. To turn on the fan, press the Fan button. To turn on the fan at high speed, press the button a second time. To turn off the fan, press the button a third time. Note: If the fan is on when the walking belt stops, the fan will automatically turn off after a few minutes. 8 When you are finished exercising, remove the key. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will be damaged. Next, remove the key from the console and put it in a secure place. Note: If the display remains lit after the key is removed, the console is in the "demo" mode. See page 16 and turn off the demo mode. When you are finished using the treadmill, switch the reset/off circuit breaker to the "off" position and unplug the power cord. 13