ProForm 650 Crosstrainer Treadmill English Manual - Page 6

ASSE2 M1/2"BBoLltY(37)-2 Star Washer (106)-4 Washer (38)-4 3/4" Screw (2)-6 To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480. 3 1/2" Bolt (45)-4 Wheel Nut (32)-2 Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transfeHrarenddrtaoilthBeolt (64)-4 top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex key and your own phillips screwdriver (with a Star Washsehraft at least 6" long) and wire cutters . Extension Leg Bolt (96)-4 (84)-2 Use the drawiEngxtsebnesilonw LtoegidBeonlttif(y9t6h)e-4hardware useWdhdeuerlinNguat s(1s3e)m-2bly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. Ground Screw (33)-1 Screw (3)-11 Star Washer (8)-8 Front Endcap Screw (14)-2 2.25" Extension Leg Bolt (92)-2 2.5" Extension Leg Bolt (65)-2 1" Tek Screw (83)-2 Extension Leg Nut (67)-2 Handrail Bolt (64)-4 1. Make sure that the power cord is unplugged. 1 With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially 84 fold the Frame (58) so the treadmill is more sta- ble. Do not fully fold the treadmill until it is completely assembled. 14 44 Insert an Extension Leg (89) into the base of the Uprights (84). Hold an Extension Leg Nut (67) in the bottom of the Extension Leg, and thread a 2.25" Extension Leg Bolt (92) with a Star Washer (8) into the top of the Extension Leg. Next, thread a 2.5" Extension Leg Bolt (65) with a Star Washer (8) into the bottom of the Extension leg. Firmly tighten the Extension Leg Bolts. Slide a Front Endcap (44) onto the base of the Upright (84). Partially tighten a Front Endcap Screw (14) into the Front Endcap and the base. 92 8 58 8 89 67 65 6