ProForm 660 Xt Uk Manual - Page 7
Handlebar Arm with two M8 x 45mm Button Bolts
View all ProForm 660 Xt manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
7. Identify the Left Handlebar (6), which is marked with a sticker. Insert the Left Handlebar into one of the 7 Handlebar Arms (5); make sure that the Handlebar Arm is turned so the hexagonal holes are on the indicated side. Attach the Left Handlebar to the Handlebar Arm with two M8 x 45mm Button Bolts (50) and two M8 Nylon Locknuts (38). Make sure that the Nylon Locknuts are inside of the hexago- nal holes. Do not fully tighten the Button Bolts yet. Attach the Right Handlebar to the other Handlebar Arm (not shown) in the same way. 6 38 50 5 Hexagonal Holes 8. Apply a generous amount of the included grease to the left axle on the Upright (2) and inside of the two small Handlebar Bushings (49) in the Left Handlebar (6). Slide a Frame Spacer (48), a Handlebar Spacer (47), the Left Handlebar (6), and a Handlebar Cap (46) onto the left axle on the Upright (2) as shown. Slide an M10 Washer (55) onto an M8 x 25mm Button Screw (56), and tighten the Button Screw into the axle. Attach the Right Handlebar (8) in the same way. 9. Apply a generous amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal Arm (11) onto the axle and attach it with an M8.5 Washer (35) and an M8 Nylon Locknut (38). Insert the left Handlebar Arm (5) into the bracket on the end of the Left Pedal Arm (11), and attach it with a Pedal Arm Bolt Set (40). Repeat this step to attach the right Pedal Arm (not shown). Refer to step 7. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Arms (5). Tighten the two M10 x 74mm Button Bolts (27). 8 8 Grease 6 46 55 56 48 47 49 2 9 27 5 40 40 11 38 35 16 Grease 7