ProForm 710 Ekg Exercise Bike Uk Manual - Page 13

MAINTENANCE AND TROUBLESHOOTING Inspect and properly tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. To clean the exercise cycle, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. PULSE SENSOR TROUBLESHOOTING For optimal performance of the pulse sensor, keep the metal contacts clean. Clean the contacts with a soft cloth-never use alcohol, abrasives, or chemicals. Avoid moving your hands while using the pulse sensor. Excessive movement may interfere with heart rate readings. Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings. For the most accurate heart rate reading, hold the metal contacts for about 15 seconds. Next, locate the Reed Switch (21). Turn the Left Crank Arm (42) until the Magnet (16) is 53 21 aligned with the Reed 16 Switch. 42 Loosen, but do not remove, the indicated M5 x 12mm Screw (53). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Crank Arm for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the left pedal. HOW TO ADJUST THE REED SWITCH BATTERY REPLACEMENT If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the left pedal and the left side shield must be removed. If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 4 on page 5. Using an adjustable wrench, turn the left pedal clockwise and remove the left pedal. Remove the screws from the left side shield. Note: There are two different sizes of screws in the left side shield. Be sure to note the location of each screw. Then, carefully pry the left side shield away from the exercise cycle. HOW TO LEVEL THE EXERCISE CYCLE If the exercise cycle rocks slightly on your floor, turn one or both of the leveling feet under the rear stabilizer. 13