ProForm 900 Treadmill Uk Manual - Page 7
Latch Housing Cover and the Latch Housing as shown.
View all ProForm 900 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. With the help of a second person, raise the treadmill Frame (55). Hold the Latch Housing (68) and the Latch Housing Cover (5) against the Frame as shown. Loosely thread the two blunt-tipped 1/2" Screws (105) into the Latch Housing Cover and the Latch Housing as shown. Do not tighten the Screws yet. Remove the knob from the pin. Make sure that the collar and the spring are on the pin. The collar should be on the indicated side of the spring. Insert the pin into the Latch Housing (68), and tighten the knob back onto it. Align the pin with the hole in the Left Handgrip (63) by sliding the Latch Housing (68) up or down. Make sure that the pin can be inserted fully into the hole. Hold the Latch Housing in place as you tighten two 1/2" Tek Screws (20) into the Latch Housing and the Frame (55). Then, tighten the 1/2" Screws (105). Note: It may be necessary to pull on the knob to access and tighten the Screws. 3 Hole Knob 63 68 20 Collar 105 5 Small Holes Spring Pin 105 55 20 4. Remove the backing from the indicated tape on the console assembly. Press the Book Holder (23) firmly onto the tape. Note: The Book Holder may be preassembled. 4 Console Assembly 23 Tape 6. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor or carpet. For your benefit, we recommend that you familiarise yourself with the TROUBLESHOOTING section on pages 26 and 27. 7