ProForm 940 Ce Elliptical English Manual - Page 22

Maintenance And Troubleshooting

Page 22 highlights

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 16. HOW TO CALIBRATE THE RAMP HOW TO ADJUST THE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the belt may need to be adjusted. To adjust the belt, first carefully pry off the right Disc Cover (41) using a flat screwdriver. Next, remove the four screws (not shown) from the center of the right Pedal Disc (40). Gently rotate the Disc away from the elliptical. 41 40 If the ramp is not functioning properly, the ramp may need to be calibrated. To calibrate the ramp, hold down the Start button and the Resistance increase button for about 5 seconds until the display on the console changes. Next, press the Start button once, and then press the Ramp increase button. The ramp will move upward and downward as it calibrates. When the ramp stops moving, the ramp is calibrated. Then, press the Start button repeatedly to return to the manual mode. Loosen, but do not remove, the three indi- cated screws (A). Insert the 57 shaft of a screw- B driver downward C between the A Idler (B) and the Idler Pulley (C). Pull the top of the screwdriver toward the front of the elliptical until the Belt (57) is tight. Then, tighten the three screws. Reattach the right disc with the four screws and then reattach the right disc cover. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

22
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap.
IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power cord is fully plugged in.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 16.
HOW TO CALIBRATE THE RAMP
If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, hold down
the Start button and the Resistance increase button
for about 5 seconds until the display on the console
changes. Next, press the Start button once, and then
press the Ramp increase button. The ramp will move
upward and downward as it calibrates. When the ramp
stops moving, the ramp is calibrated. Then, press the
Start button repeatedly to return to the manual mode.
HOW TO ADJUST THE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the belt
may need to be adjusted.
To adjust the belt,
first carefully pry
off the right Disc
Cover (41) using
a flat screwdriver.
Next, remove the
four screws (not
shown) from the
center of the right
Pedal Disc (40).
Gently rotate the
Disc away from
the elliptical.
Loosen, but do
not remove,
the three indi-
cated screws
(A). Insert the
shaft of a screw-
driver downward
between the
Idler (B) and the
Idler Pulley (C).
Pull the top of
the screwdriver
toward the front
of the elliptical until the Belt (57) is tight. Then, tighten
the three screws.
Reattach the right disc with the four screws and then
reattach the right disc cover.
MAINTENANCE AND TROUBLESHOOTING
41
40
B
C
A
57