ProForm 940 Ce Elliptical English Manual - Page 9

5. Apply a generous amount of the included grease to the Pivot Axle (33) and to two 5/8" Wave Washers (102). Tip: Avoid pinching or damaging the Upper Wire Harness (97). Insert the Pivot Axle (33) through the Upright (6). Then, slide a 5/8" Wave Washer (102) onto each end of the Pivot Axle. Slide an Upper Body Arm (12) onto the left side of the Pivot Axle (33). Attach the Upper Body Arm with a 5/16" x 1" Screw (81), a Large Axle Cover (94), and a 5/16" Washer (104). Attach the other Upper Body Arm (12) in the same way. 5 104 97 81 94 102 12 6 Grease 33 102 104 94 81 12 6. Identify the Right Pedal Plate (107). Attach the Right Pedal Plate to the Right Pedal Arm (8) with 6 three M10 x 20mm Screws (108) and three M10 62 Split Washers (110). Identify the Right Pedal Assembly (62), which is located in a package marked with a “"Right”" sticker. Attach the Right Pedal Assembly (62) to the right Pedal Plate (107) with five #10 x 1/2" Screws (79), five M6 Split Washers (111), and five #10 Fender Washers (80). Tip: To avoid damaging the Pedal, do not overtighten the Screws. Repeat this step for the Left Pedal Plate (not shown) and the Left Pedal Assembly (56). 108 110 107 56 80 8 111 79 79 9