ProForm 990 Cse Elliptical English Manual - Page 8

4. Apply a generous amount of the included grease to the Upright Axle (48) and to two Wave Washers (118). Tip: Avoid damaging the Wire Harness (60). Insert the Upright Axle (48) through the Upright (5) and center it. Slide a Wave Washer (118) onto each side of the Upright Axle. Next, identify the Right and Left Upper Body Legs (6, 7), which are marked with “"Right”" and “"Left”" stickers, and orient them as shown. Slide the Right and Left Upper Body Legs (6, 7) onto the right and left sides of the Upright Axle (48). Tighten an M8 x 16mm Screw (102) and an M8 Washer (95) into each end of the Upright Axle (48). 4 60 102 95 118 7 5 Avoid damaging the Wire Harness (60) Grease 48 118 95 102 6 5. Identify the Right Pedal (14), the Right Gel Pad 5 (55), and the Right Pedal Arm (12), which are marked with “"Right”" stickers, and orient them as shown. Set the Right Gel Pad (55) on the Right Pedal Arm (12). Then, set the Right Pedal (14) on the Right Gel Pad. Attach the Right Pedal (14) to the Right Pedal Arm (12) with two M6 x 50mm Screws (62), two M6 x 12mm Screws (111), and four M6 Washers (112). Attach the Left Pedal (not shown) and the Left Gel Pad (not shown) to the Left Pedal Arm (not shown) in the same way. 14 55 12 112 112 111 111 62 62 8