ProForm C830 Elliptical English Manual - Page 8

9. Apply a small amount of the included Teflon® lubricant to a paper towel. Rub a thin film of the lubricant onto the Handlebar Legs (79). Next, identify the Left Handlebar (9) and the Right Handlebar (10), which are marked with stickers. Slide the Left Handlebar onto the left Handlebar Leg, and slide the Right Handlebar onto the right Handlebar Leg. Make sure that the Handlebars are on the correct sides-the upper ends should bend in the direction shown. Apply a generous amount of grease to the Pivot Axle (88). Insert the Pivot Axle into the Right Handlebar (10) and a Handlebar Spacer (25) as shown. Next, insert the Pivot Axle into the Upright (2) until the left end of the Pivot Axle is flush with the left side of the Upright. Then, insert the Pivot Axle through the other Handlebar Spacer (25) and the Left Handlebar (9). Make sure that the Handlebar Spacers are turned so the small arrows are pointing toward the floor. Slide an M8.5 Washer (53) and a Wave Washer (116) onto each of the two M8 x 25mm Patch Screws (22). Tighten the Patch Screws into the ends of the Pivot Axle (88) at the same time. Then, press the tabs on the two Handlebar Caps (23) into the Handlebar Spacers (25). Tighten the M10 x 85mm Button Screw (63). 10. Attach the Water Bottle Holder (91) to the Upright (2) with two M4 x 22mm Screws (93). 9 10 9 116 23 53 22 25 79 Arrow Grease 22 23 88 53 116 25 2 Lubricate 63 79 Lubricate 10 91 93 2 8