ProForm Crosswalk 3.0 Xt Treadmill English Manual - Page 7

2. Identify the Right Upright (39), which has a square hole in the location shown. 2 Orient the Right Upright (39) and the Base (37) as shown. Attach the Right Upright to the Base with two Upright Bolts (4) and two Upright Star Washers (6); do not tighten the Upright Bolts yet. 39 37 Square Hole 6 4 3. Orient the Left Upright (38) as shown. Note the 3 location of the two small latch holes. Attach the Left Upright to the Base (37) with two Upright Bolts (4) and two Upright Star Washers (6); do not tighten the Upright Bolts yet. Raise the Uprights (38, 39). Latch Holes 39 37 38 4. Lay the Power Cord (73) on the Hood (56), and 4 position the Base (37) near the front of the tread- mill as shown. Cut the small tie (not shown) holding the Upright Wire (69) in a bundle. Wrap the indicated tie around the Upright Wire (69) Then, insert the end of the Upright Wire into the square hole in the Right Upright (39). Pull the opposite end of the strap until the end of the Upright Wire is pulled through the Right Upright. 7 73 56 69 39 Tie 37 6 6 4 39 69 Tie