ProForm Endurance 420e Instruction Manual - Page 12

13. Apply a small amount of grease to one of the Pedal Arm Axles (64). 13 While a second person holds the front end of the Right Pedal Arm (58) inside the bracket on the Right Upper Body Leg (60), insert the Pedal Arm Axle (64) into both parts. Next, slide an M8 Washer (77) onto an M8 x 13mm Screw (82), and tighten the Screw a few turns into the Pedal Arm Axle (64). Then, 46 tighten both Screw and Axle at the same time. Repeat this step on the other side of the elliptical. 82 77 60 Grease 64 58 14. Orient the Rear Upright Cover (81) as shown. 14 Attach the Rear Upright Cover (81) to the Upright (4) with four M4 x 16mm Screws (101); start all 12 the Screws, and then tighten them. Next, orient the Front Upright Cover (12) as shown. Attach the Front Upright Cover (12) around the Upright (4) by pressing it onto the Rear Upright Cover (81). 101 4 81 12