ProForm Endurance 420e Instruction Manual - Page 9
Make sure that the Locknuts are in
![]() |
View all ProForm Endurance 420e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
7. Using a plastic bag to keep your fingers clean, apply some of the included grease to the Pivot Axle (35). Insert the Pivot Axle (35) through the Upright (4) and center it. Tip: It may be helpful to use a rubber mallet. Next, slide a Pivot Spacer (54) onto the right side of the Pivot Axle (35). Then, identify the Right Upper Body Leg (60), orient it as shown, and slide it onto the right side of the Pivot Axle (35). Repeat these actions for the Left Upper Body Leg (46). Then, tighten an M8 x 13mm Screw (82) with an M8 Washer (97) into each end of the Pivot Axle (35) at the same time. 7 82 97 4 35 Grease 54 60 46 97 82 8. Identify the Right Upper Body Arm (61) and orient it as shown. Slide the Right Upper Body Arm (61) onto the Right Upper Body Leg (60). Attach the Right Upper Body Arm (61) with two M8 x 38mm Bolts (96) and two M8 Locknuts (102). Make sure that the Locknuts are in the hexagonal holes (C). Repeat this step for the Left Upper Body Arm (47). 8 47 102 60 C 61 96 9
![](/manual_guide/products/proform-endurance-420e-instruction-manual-b4a45a8/9.png)