ProForm Hiit 7 Instruction Manual - Page 25
Maintenance And Troubleshooting
View all ProForm Hiit 7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the trainer is used. Replace any worn parts immediately. To clean the trainer, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power adapter is fully plugged in. If a replacement power adapter is needed, call the telephone number on the cover of this manual. IMPORTANT: To avoid damaging the console, use only a manufacturer-supplied regulated power adapter. If the console does not boot up properly, or if the con- sole freezes and does not respond, reset the console A to the factory default set- tings. IMPORTANT: Doing this will erase all custom settings you have made to the console. Resetting the console requires two people. First, unplug the power adapter. Next, locate the small reset opening (A) on the back or the side of the console. Using a bent paper clip, press and hold the reset button inside the opening, and have a second person plug in the power adapter. Continue holding the reset button until the console turns on. When the reset operation is complete, the console will turn off and then turn back on. If it does not, unplug and then plug in the power adapter. Once the console turns on, check for firmware updates (see HOW TO CHANGE CONSOLE SETTINGS on page 22). Note: It may take a few minutes for the console to be ready for use. PEDAL TROUBLESHOOTING If the pedals bottom out while you are exercising and become difficult to move, rock your weight backward and forward on the pedals until the pedals become free and the flywheel inside the trainer begins turning again. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first unplug the power adapter. Next, remove the four indicated M4 x 16mm Flat Head Screws (101) and the Lower Rear Shield Cover (68). 68 101 101 101 25