ProForm Hse 700 Elliptical English Manual - Page 6

ASSEMBLY Assembly requires two people. Place all parts of the PROFORM® HSE700 in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires a phillips screwdriver mallet . , two adjustable wrenches , and a rubber 1. While another person holds the Upright (3) near the 1 Frame (1) as shown, gently pull the Resistance Cable (26) and the Sensor Wire (25) out of the top of the Upright until there is no slack between the Upright and the Frame. Slide the Upright (3) onto the welded bolts on the Frame (1). Be careful to avoid pinching the Resistance Cable (26) and the Sensor Wire (25). Tighten an M10 Nylon Locknut (29) onto each welded bolt. 26 25 3 29 1 Welded Bolts 2. While another person holds the Console (6) near the Upright (3), connect the console wire to the Sensor Wire (25). Feed the slack Sensor Wire (25) back down into the Upright (3). Attach the Console (6) to the Upright with four M4 x 16mm Round Head Screws (38). Be careful to avoid pinching the Sensor Wire (25). Press the Resistance Knob (50) onto the Resistance Control (26). 2 6 Console Wire 25 38 50 26 3 6