ProForm R 600 Rower Uk Manual - Page 12

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Inspect and tighten all parts of the rower regularly. Replace any worn parts immediately. To clean the rower, use a damp cloth and a small amount of mild detergent. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. For best results, clean the rail, the seat carriage, and the carriage rollers daily. Next, see the EXPLODED DRAWING on page 15. Locate the Right and Left Shields (7, 8), and remove the four M4 x 19mm Screws (69) and the ten M4 x 16mm Screws (68) from the Right and Left Shields. Then, gently remove the Right and Left Shields. Locate the Reed Switch (47). Turn the Left Fan (4) until a Magnet (77) is aligned with the Reed Switch. Loosen, but do not remove, the two indicated M4 x 19mm Screws (69). Then, slide the Reed Switch slightly closer to or away from the Magnet, and retighten the Screws. CONSOLE TROUBLESHOOTING Most console problems are the result of low batteries; for replacement instructions, see assembly step 6 on page 7. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the resistance handle and the right and left shields as described below. First, remove the six M4 x 10mm Screws (70), 70 and then gen- tly remove the Resistance 9 Handle (9). 70 47 4 77 69 Turn the Left Fan (4) so that the Magnet (77) passes the Reed Switch (47) repeatedly. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the parts that you removed. 12