ProForm Spacesaver 600 Elliptical English Manual - Page 16
How To Use A Cross Training Workout
View all ProForm Spacesaver 600 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
When your pulse is detected, a heartshaped symbol will flash in the left display. Each time your heart beats, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, hold the contacts for at least 15 seconds. Note: If you continue to hold the handgrip pulse sensor, the display will show your heart rate for up to 30 seconds. If your heart rate is not shown, make sure that your hands are positioned as described. Be careful not to move your hands excessively or to squeeze the metal contacts tightly. For optimal performance, clean the metal contacts using a soft cloth; never use alcohol, abrasives, or chemicals to clean the contacts. 6. Turn on the fan if desired. HOW TO USE A CROSS TRAINING WORKOUT 1. Turn on the console. See step 1 on page 15. 2. Select a cross training workout. To select one of the six cross training workouts, press the Workout button repeatedly until the name of an UPPER BODY, LOWER BODY, or TOTAL BODY workout appears in the upper display. Profile The fan has high and low speed settings. Press the Fan button repeatedly to select a fan speed or to turn off the fan. Note: If the pedals do not move for about thirty seconds, the fan will turn off automatically. When you select a cross training workout, the name of the workout and the workout time will appear in the displays and a profile of the resistance levels of the workout will scroll across the center display. Pivot the thumb tab on the right side of the fan to adjust the fan angle. Thumb Tab 7. When you are finished exercising, the console will turn off automatically. If the pedals do not move for several seconds, a series of tones will sound, the console will pause, and the time will flash in the display. If the pedals do not move for about five minutes, the console will turn off and the display will be reset. 3. Begin pedaling to start the workout. Each workout is divided into 25, 30, or 45 oneminute segments. One resistance level and one target rpm (revolutions per minute) setting are programmed for most segments. (Note: The same resistance level and/or target rpm setting may be programmed for consecutive segments.) During other segments, the console will prompt you to perform strength exercises. During the workout, the workout profile will show your progress (see the drawing above). The flashing segment of the profile represents the current segment of the workout. The height of the flashing segment indicates the resistance level for the current segment. At the end of each segment of the workout, a series of tones will sound and the next segment of the profile will begin to flash. If a different resistance level is programmed for the next segment, the resistance level will appear in the display for a few seconds to alert you. The resistance of the pedals will then change. 16