ProForm Spacesaver 930 Elliptical English Manual - Page 10

11. Orient a Link Arm (30) as shown. Attach the Left Pedal (34) to the Link Arm with three 11 M8 x 45mm Button Screws (90), three M8 Split Washers (97), and three M8 x 23mm x 2mm Washers (96). Attach a Pedal Arm Cover (39) to the Link Arm (30) with an M4 x 16mm Round Head Screw (80). Repeat this step for the Right Pedal (not shown) and the other Link Arm (not shown). 34 80 39 96 97 96 30 97 90 12. Apply a generous amount of grease to the axle on the Left Upper Body Leg (24) and to the axle 12 on the left Crank Arm (55). Then, apply grease 24 to two Large Wave Washers (102). 32 Grease Slide an Upper Body Leg Spacer (9) and a Large Wave Washer (102) onto the Left Upper Body Leg (24). Make sure that the flat side of the Upper Body Leg Spacer is facing out- 102 9 31 ward. Then, slide the other Large Wave Washer 66 (102) onto the left Crank Arm (55). Slide the left Pedal Arm (32) onto the Left Upper Body Leg (24) while sliding the left Link Arm (30) onto the axle on the left Crank Arm (55). 86 95 32 Attach the Pedal Arm (32) to the Left Upper Body Leg (24) with an M8 x 23mm Button 30 Screw (86), an M8 Washer (95), an Axle Cover (66), and an M8 x 23mm x 1mm Washer (31). Then, attach the Link Arm (30) to the Crank Arm (55) with an M8 x 23mm Button Screw (86), an M8 Washer (95), a Large Axle Cover (52), and an M8 x 23mm x 1mm Washer (31). Repeat this step for the right Pedal Arm (32) and the right Link Arm (30). See step 4. Tighten the M8 x 19mm Button Screws (85). 30 102 31 95 52 86 55 Grease 13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 10