ProForm Strideselect 830 Elliptical English Manual - Page 9
Button Bolts 67. See step 10. Tighten the M8 x
View all ProForm Strideselect 830 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
10. Identify the Left Handlebar (9), which is marked with a sticker. Insert the Left Handlebar into one of the 10 Handlebar Legs (79); make sure that the Handlebar Leg is turned so the hexagonal holes are on the indicated side. Attach the Left Handlebar with two M8 x 45mm Button Bolts (50) and two M8 Nylon Locknuts 9 (46). Make sure that the Nylon Locknuts are inside of the hexagonal holes. Do not tighten the Button Bolts yet. Assemble the Right Handlebar (not shown) and the other Handlebar Leg (not shown) in the same way. 46 50 Hexagonal Holes 79 11. Apply a generous amount of the included grease to the Pivot Axle (81) and to the two M8 Washers (53). Next, insert the Pivot Axle into the Upright (2) and center it. Reapply grease to both ends of the Pivot Axle. Slide a Handlebar Spacer (25) onto the short tube on the Left Handlebar (9), and rotate the Handlebar Spacer so the small arrow is pointing toward the floor. Next, slide the Left Handlebar onto the left end of the Pivot Axle (81). Finger tighten an M8 x 25mm Patch Screw (22) with an M8 Washer (53) and a Wave Washer (91) into the end of the Pivot Axle. Then, press the small tabs on a Handlebar Cap (23) into the Handlebar Spacer. Assemble the Right Handlebar (10) in the same way. Make sure that both Wave Washers (91) are on the Pivot Axle (81), and then tighten both M8 x 25mm Patch Screws (22) at the same time. 11 9 2 Grease Grease 53 91 22 23 25 81 Arrow Tube 10 Tube 25 Arrow 23 53 22 91 Grease 12. Apply a small amount of grease to an M10 x 59mm 12 Bolt Set (27) and to the surfaces of the Leg Bushings 79 (28) in the left Handlebar Leg (79). Attach the left Handlebar Leg to the Left Pedal Arm (14) with the Bolt Set. Do not overtighten the Bolt Set; the left Handlebar Leg must be able to pivot freely. Attach the right Handlebar Leg (79) to the Right Pedal 79 Grease 75 28 28 27 Arm (75) in the same way. Grease 14 See step 3. Tighten the two M10 x 83mm Button 27 Screws (63). See step 4. Tighten the two M8 x 70mm Button Bolts (67). See step 10. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Legs (79). 13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 9