ProForm Vr900 Ekg Bike English Manual - Page 5

1. While another person holds the Upright (6) in the position shown, connect the Extension Wire (18) to the Reed Switch Wire (20). Refer to the inset drawing. Make sure that the plastic sheath is in the location shown. Insert the tip of the Resistance Cable (22) into the indicated opening in the Cable Connector (69). Then, pull up on the Resistance Cable and insert it into the top of the Cable Connector. Center the sheath on the Cable Connector. Carefully slide the Upright (6) onto the Frame (1). Be careful to avoid pinching the wires and cables. Loosely thread four M10 x 25mm Button Screws (71) with M10 Split Washers (17) through the Upright and into the Frame. Secure the tops of the Side Shields (4, 5) with two M4 x 16mm Screws (21). Firmly tighten the four Button Screws in the following order: front, rear, and then sides. 1 Front 71 17 Side 22 69 Sheath 21 2. Attach the Front Stabilizer (2) to the front of the 2 Frame (1) with two M10 x 75mm Carriage Bolts (72) and two M10 Nylon Locknuts (45). 72 6 Side 22 17 71 69 18 Rear 20 21 145 Sheath 2 3. While another person holds the Handlebar (16) near 3 the Upright (6), route the Pulse Wires (33) up through the two indicated holes in the Upright. Attach the Handlebar (16) to the Upright (6) with two M10 x 25mm Button Screws (71) and two M10 Split Washers (17). Do not tighten the Button Screws yet. Make sure that no wires are pinched between the Handlebar and the Upright. 18 Hole 6 4. The Console (9) requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, turn the console over, open the battery door, and insert two batteries into the battery clip as shown. Make sure that the negative ends of the batteries (marked "-") are touching the springs in the battery clip. Close the battery door. 4 9 Battery Door 5 1 45 16 Hole 33 17 Batteries 17 71 Battery Clip