ProForm Vr900 Ekg Bike English Manual - Page 6
the Frame 1. Attach the Carriage Bar to the Frame
View all ProForm Vr900 Ekg Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
5. Hold the Console (9) near the Upright (6) as shown. 5 Identify the green console ground wire and attach it to the Upright with an M4 x 16mm Screw (21). Next, connect the Reed Switch Wire (18) and the two Pulse Wires (33) to the corresponding wires on the Console (9). Console Wires 18 33 6 9 Console Ground 21 Wire 6. Attach the Console (9) to the Handlebar Post (6) 6 with four M4 x 16mm Screws (21). Make sure that no wires are pinched between the Console and 9 the Handlebar Post. Press the Resistance Knob (75) onto the Resistance Control (22). Refer to step 3. Tighten the two M10 x 25mm Button 6 Screws (71) used in step 3. 75 22 7. Slide the Carriage Bar (7) onto the indicated tube on 7 the Frame (1). Attach the Carriage Bar to the Frame with four M10 x 25mm Button Screws (71) and four M10 Split Washers (17). Slide the Seat Carriage (11) onto the Carriage Bar (7) as shown. Thread the Seat Knob (74) clockwise into the Seat Carriage until it is tight. 21 1 17 71 7 71 74 11 6