ProForm Xp Thinline 480 Elliptical Canadian English Manual - Page 7
Tip: Avoid pinching the Wire Harness 100.
View all ProForm Xp Thinline 480 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Tip: Avoid pinching the Wire Harness (100). Start all screws before tightening any of 3 them. Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright. Tie the lower end of the wire tie to the Wire Harness (100). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside the Upright, secure the Wire Harness with a rubber band. Attach the Upright (2) to the Frame (1) with four M10 x 20mm Patch Screws (79), and four M10 Split Washers (78). Do not tighten the Patch Screws yet. Wire Tie 2 79 78 100 1 Avoid pinching the Wire Harness (100) 78 79 78 79 4. Orient the Water Bottle Holder (5) as shown and slide it onto the Upright (2). Attach the 4 Water Bottle Holder with two M4 x 32mm 3 Screws (95). Avoid pinching Tip: Avoid pinching the Wire Harness (100). Slide the Console Cover (96) onto the Upright (2) and move it downward to the Water Bottle the Wire Harness (100) 96 100 Holder. Then, insert the Console Bracket (3) 84 into the top of the Upright. Attach the Console Bracket with four M4 x 16mm Screws (84). 84 2 5 95 7