ProForm Ze3 Elliptical English Manual - Page 9

6. The Console (4) can use four D batteries (not included); alkaline batteries are recommended. Do not use old and new batteries together or alkaline, standard, and rechargeable batteries together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic components. Remove the screws, remove the battery covers, and insert the batteries into the battery compartments. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. Then, reattach the battery covers. To purchase an optional power adapter, call the telephone number on the cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power adapter. Plug one end of the power adapter into the receptacle on the console; plug the other end into an outlet installed in accordance with all local codes and ordinances. 6 Screws Batteries 4 Battery Covers Batteries 7. Untie and discard the wire tie attached to the Wire Harness (42). Locate the Pulse Wires (28) inside the left and right sides of the Handlebar (39) and pull them upward out of the Upright (2). While a second person holds the Console (4) near the Upright (2), connect the wires on the Console to the Wire Harness (42) and to the Pulse Wires (28). Insert the excess wires into the Upright (2) or the Console (4). Tip: Avoid pinching the wires. Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (92). 7 4 42 28 2 92 92 39 Avoid pinching the wires 9