Pyle PCT60 User Guide - Page 3

Intermittent Connections To test for broken connections 1. While in test mode with a cable plugged into both an In and Out, press the reset button to clear the Intermittent LED's. 2. Next, move the suspected cable end around vigorously while plugged in. 3. If there are any shorted, loose, or broken connections, one of the Intermit- tent LED's will light up showing where the break is taking place. 4. Press Reset to clear the LED's to continue or try again. Installed Cable Mode To test the integrity of a fixed cable or one in which both ends are unable to be connected. 1. To enter Installed Cable Mode, Press and hold the Reset button while Switching from off to Cable Tester. The On LED light will on and off to indicate that you are in Installed Cable Tester Mode. 2. Insert a cable into the one of the outputs. 3. The LED grid will now show any short circuits, if any by indicating which out pins are connected. If there are no LED's lit, then there are not short circuits in the cable. To test for continuity in Installed Cable Mode 1. With the Installed cable plugged into the output of the cable tester, attach a shorting jack to the other end of the cable, or connect the ends. 2. If the integrity of the cable is intact, the short circuit should show up on the cable tester. If it does not, then there is a break in the cable. 3