Pyle PLMRA210BT User Guide - Page 4

Connect+ 12V DC power supply wire Into the terminal from the BATT +12V terminal of the fuse at battery. (Fuse preferably installed 1 foot within 1 foot from the battery). GROUND Ground terminal connect the ground wire to the chassis of the automobile, boat or other vehicle. REMOTE Remote terminal connects the control wire which provides remote turn-on and power off. When the amp is properly grounded and has proper power and 6 Power on LED Is receiving Its remote power signal the green LED will light up indicating power conditions are correct. 7 Protection LED This Is Indicator Is Illuminated when built-in protection circuitry Is activated. 8 Power Fuse Power fuse protects both this amplifier and the automobile electrical system from wrong electrical conditions. The speaker terminals are silver-plated for high conductivity and minimum Impedance loss. Be sure to strip just enough Insulation off your speaker wires that will fit under the screw 9 Speaker Terminals plate to help ensure against speaker wire short circuits. The amp can support an impedance load as low as 2 ohms per channel or 4 ohms in the bridged mode, though a 4 ohm stereo load and 8 ohms bridge load will greatly Increase the life expectancy of the amplifier. 10 Crossover Frequency Circuit Lets you adjust the crossover frequency from 40-450 Hz for both channels. 11 Crossover On/Off Switch Allows for operation to run at full range or with built-in crossover use. The Pyle Elite Series Amps feature options and configurations that vary among the various models in the amplifier line availability. Refer to the specific model number for detailed amplifier connection options and features. Visit us online for detailed specifications and more information. www.PyleAudio.com Elite Series Waterproof Amplifiers