Pyle PLUTV58BKA Instruction Manual - Page 3

Black Blue +12V Red + 12V = POWER SUPPLY Connect the BATT terminal to the positive pole of the battery with a lead cable and add a fuse into the power cable in a distance of not more than 30 cm from the battery. The lead cable's diameter should be at least 4 mm' for a length of 3 m and 6 mm" for a length of 6 m. REM (ON/OFF) REMOTE CONTROL Connect the REM terminal to the automatic antenna connector of your vehicle/or boat radio. Now when turning on and off your vehicle/or boat radio, the amplifier automatically switches ON and OFF. A cable diameter of 0.5mm2 is sufficient. SPEAKERS CONNECTIONS L-OUTPUT+ White L-OUTPUT- White+Black R-OUTPUT+ Grey R-OUTPUT- Grey+Black Line OUT White ( L ) OUT Red ( R ) AUX Input AUX Input Black + 12V Red GND Black REM Blue R-OUTLP-UOLTU-O+TUP(GTUPTrUe-Ty(W+) (hWiteh+iteB)lack) R-OUTPUT- (Grey+Black) AUX Input 4 www.PyleUSA.com POWER CONNECTION LEADS Line Out R Line Out L NOTES ON THE POWER SUPPLY • Connect the +12V power input lead only after all other leads have been connected. • Be sure to connect the ground wire of the unit securely to a metal part of the vehicle/or boat. • Loose or faulty connection may cause amplifier malfunction • REM: The unit is turned on by applying +12 Volts to this terminal. This terminal does not draw heavy current like the tow Power Terminals so a thinner connecting wire is acceptable. Standard 18 GAUGE is fine and the standard color is red. If the radio is equipped with a Power Antenna control wire, it can drive this terminal. If the Power Antenna wire is already in use, you can still splice into it. With this method, the unit will turn ON automatically with the radio. • Use the power supply lead with a fuse attached whose value is the same as original fuse. • Place the fuse in the power supply lead as close as possible to the car battery. • During a full power operation, Maximum current will run through the system. Therefore, make sure that the leads to be connected to the +12V and GND terminals of the unit respectively must be larger than 18-Gauge (AWG.18) proper Bridged operation. If only mono signal is available, a "Y" adapter is required. FUSE REPLACEMENT If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In this case, consult your dealer. WARNING Use the specified amperage fuse. Use of a higher amperage fuse may cause serious damage. www.PyleUSA.com 5