Pyle PTA1 PTA1 Manual 1 - Page 4
Aux/cd Rca Input - amp
View all Pyle PTA1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
music will be existed at the same time. It is similar like playing at KARAOKE events. 8. 1/4" MIC INPUT JACK -Lets you connect a microphone with a 1/4" plug. 9. AUX/CD RCA INPUT -Lets you connect most high-level audio sources such as CD player, tape deck, tuner, camcorder or VCR. 10. SPEAKER L/R TERMINALS -Lets you easily connect speaker wires directly to the amplifier.Speaker impedance can range from 8 to 4 ohms for the general stereo output. please see the next instruction of using four 8-ohm speskers for stereo mode connection. 11. VOLTAGE SELECTOR -Lets you select the voltage of AC power input source. The amplifier has selectable input voltage from 110v/60Hz which is the standard in USA and CANADA. You can also switch the input voltage to 230V/50Hz for EUROPEAN opeation. Please make sure the switch is in the proper position before operating, otherwise severe damage will result not cover by the warranty. Please also replace the fuse with proper rating in this situation (see the next instruction for the fuse rating). 12. FUSE -The amplifier uses a fuse for protection against surges and short circuit. If the amplifier suddenly turns off and will not turn on, check the fuse, If necessary, replace it with a 1-amp, 250-volt, fast-acting, 5 x20mm fuse (not supplied). 2