Pyle SLACHT108 Instruction Manual - Page 9

Dehumidi cation Mode • When pressing mode key or choosing dehumidi cation mode by pressing the remote controller, the dehumidi cation indicator lamp lights up. • Remove the dehumidi cation water wedge, insert water manifold, place the other end of the water manifold into the water vessel or drainage passage, as shown in the right gure. • After entering the dehumidi cation mode, if room tempearture≥17°C (62°F), the compressor is ON. Then control as follows: when room temperature ≤15°C (59°F), the compressor is OFF; when temperature increases to room temperature≥17°C (62°F), the compressor will start again (in order to protect the compressor, it will be restarted 3min. later). • In dehumidi cation mode, the fan is defaulted to run at low speed, and wind speed can't be adjusted. • Temperature can't be set. Auto mode (for cooling model only) • When pressing mode key or choosing auto mode by pressing the remote controller, the auto indicator lamp lights up. • After choosing Auto mode, operation state is determined by environmental temperature: when environmental temperature is higher than 25°C (77°F), the operation state is the same as that of cooling mode; when environmental temperature is lower than 25°C (77°F), the operation state is the same as that of fan mode. Timer Mode • In standby state, press the Timer key to set ON time. Press Up and Down keys to set ON time (1~24H), and the timer indicator lamp lights up. • In ON state, pressure the timer key to set OFF time. Press Up and Down keys to set OFF time (1~24H), and the timer indicator lamp lights up. Clean and Maintenance DRAINAGE METHOD This product is equipped with automatic water vaporization system. The condenser is cooled with the circulating of condensing water, so as to improve cooling e ciency and save energy. www.SereneLifeHome.com 9