RCA ANT700R User Guide - Page 2

If you're mounting to concrete, brick, or drywall... You'll need to use the anchors included in this package. Here's how to install them: • Place the antenna base against the concrete where you want to mount the antenna. Make sure it's level. • Mark the surface through the holes in the base where you're going to mount the antenna. • Set the base aside and drill a 0.1575" pilot hole at each marked location. Remove any excess dust from the holes. • Insert a concrete anchor into each hole so that it is flush with the concrete surface. You can use a hammer to gently tap the anchors into place if necessary. • Place the antenna base back against the concrete surface and secure it using the four wood screws provided. Do not overtighten these screws. 2. Attach the arm to the base. Find one of the bolts and hex nuts included in this package. First, set the bolt in the base's mounting well. Then position the arm over the other side of the well. Tighten the nut to attach the arm to the base. ENGLISH 3. Attach the antenna to the arm. Find the other bolt and hex nut included in this package. First, set the bolt in the antenna's mounting well. Then position the arm over the other side of the well. Tighten the nut to attach the arm to the antenna. 4. Connect the coaxial cable to the antenna. Connect the coaxial cable to the F-connector on the bottom of the antenna. Cover the connector with the cable's attached weather boot. continues on next page... 3 4