RCA ANT700R User Guide - Page 3

To adjust the antenna's position: 1. Loosen the bolt on either end of the arm. 2. Move the arm or antenna to the desired position. 3. Re-tighten the bolt so that the antenna and arm stay firmly in position. Mounting to a Mast 1. If you're using the provided coaxial cable, thread it through one of the U-bolts. Find the coaxial cable and one of the U-bolts included in this package. Thread the coaxial cable through the U-bolt as shown here. IMPORTANT: If you're not using the coaxial cable that came with this antenna, skip step 1. 2. Attach the clamp assemblies to the base. Find the other U-bolt, the four washer nuts, the two clamps, and the antenna base included in this package. Insert each U-bolt into the base as shown here. Then position a clamp and two washer nuts on the end of each U-bolt as shown here. ENGLISH 3. Mount the base to the mast (not included). Slide the antenna clamp assembly over the mast, positioning the mast between the clamp and the antenna base. Position the antenna base as high as possible on the mast. Orient the base in the direction you want. Then tighten the clamps and washer nuts securely onto the mast. Note: If you used the provided coaxial cable, make sure to mount the base so that the cable exits downward. 4. Attach the arm to the base. Find one of the bolts and hex nuts included in this package. First, set the bolt in the base's mounting well. Then position the arm over the other side of the well. Tighten the nut to attach the arm to the base as shown here. continues on next page... 5 6