Reebok 825 English Manual - Page 13

Arm Assembly 20 20. Note: Some of the parts used in arm assembly are located in the parts bag labeled ÒSeat Assembly.Ó 50 Attach the Press Arm (46) to the Press Frame (12) with two 3/8Ó x 3Ó Bolts (45) and two 3/8Ó Nylon Locknuts (50). 12 50 46 45 21. Press a 2Ó Square Inner Cap (33) into each end of the Press Arm (46). Insert a Handle (20) into the indicated hole on one side of the Press Arm (46) from the direction shown. Note that on one side the Handle has a groove with a series of adjustment holes (A). These holes must be turned towards the Adjustment Knob (9). Make sure the Grip (58) is pointed towards the center of the unit on both Handles. 21 46 9 Unscrew the handle on the Adjustment Knob (9) and pull it out. Slide the press arm Handle (20) into the 58 Press Arm. Release the handle on the Adjustment A 33 Knob and let it snap into one of the adjustment holes (A). Tighten the handle on the Adjustment Knob fully. Repeat this procedure for the second Handle. 20 Hole Seat Assembly 22 22. Attach the Seat (13) to the Seat Upright (37) with four 1/4Ó x 3/4Ó Bolts (17). Unscrew the handle on the Adjustment Knob (9) until it is loose. Pull out the handle as far as it will go and slide the Seat Upright (37) into the seat frame on the Main Upright (3). Release the handle and let the Knob snap into one of the adjustment holes on the Seat Upright. Tighten the handle fully. 13 3 37 17 9 13 9 A 58 33 17 Adjustment Holes