Reebok 8600 Es Treadmill English Manual - Page 10

11. With the help of a second person, carefully lower the Uprights (85) to a vertical position. Attach the Right Base Cover (86) with three 3/4" Screws (7) and two Base Cover Screws (63). Start all five Base Cover Screws before tightening them. Be careful not to overtighten the Base Cover Screws. Attach the Left Base Cover (88) in the same way. With the help of a second person, carefully raise the Uprights (85) to a vertical position. 11 85 86 7 88 63 7 63 12. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place. The hex key is used to adjust the walking belt (see page 28). To protect the floor or carpet from damage, place a mat under the treadmill. If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 3/4" Screws (7) from the 1 back of the Console Base (98). 105 98 7 7 77 7 7 7 2. While a second person holds the Console (105), connect the wire on the receiver (A) to the indi- 2 cated wire extending from the Console. Next, hold the receiver so the small cylinder is ori- ented as shown and is facing away from the Console. Attach the receiver to the Console in the location shown with the two included Small Screws (B). 3. Make sure that no wires are pinched. See drawing 1. Reattach the Console (105) to the Console Base (98) with the 3/4" Screws (7). Discard the other wires included with the receiver. 10 Wire A Cylinder 98 105 B