Reebok 8700es Treadmill English Manual - Page 11

the Access Door 87 from the Console Base

Page 11 highlights

13. Press the Left Accessory Tray (99) and the Right Accessory Tray (106) into the Console 13 Base (91). 91 99 106 14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 27 and 28). If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated #8 x 3/4" Screw (1) and the Access Door (87) from the Console Base (91). 2. Connect the wire on the receiver to the indicated wire extending from the Console Base (91). Hold the receiver so the antenna is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (87) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (87) with the #8 x 3/4" Screws (1). Discard the other wires included with the receiver. Wire 91 Small Screws 87 Receiver 1 Antenna 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

11
If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screw (1) and
the Access Door (87) from the Console Base
(91).
2.
Connect the wire on the receiver to the indicated
wire extending from the Console Base (91).
Hold the receiver so the antenna is oriented
as shown and is facing the Console Base.
Attach the receiver to the plastic posts on the
Access Door (87) with the two included small
screws.
3.
Make sure that no wires are pinched.
Reattach the Access Door (87) with the #8 x
3/4" Screws (1). Discard the other wires in-
cluded with the receiver.
Receiver
87
Antenna
1
91
Wire
14.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 27 and 28).
13. Press the Left Accessory Tray (99) and the
Right Accessory Tray (106) into the Console
Base (91).
91
99
106
13
Small Screws