Reebok Vista 8500 Treadmill English Manual - Page 14
demo mode. See HOW TO USE THE INFOR
View all Reebok Vista 8500 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
The right display-This display will show the distance that you have walked or run, the speed of the walking belt, the incline level of the treadmill, your pace (in minutes per mile), and the approximate numbers of calories and fat calories you have burned (see FAT BURNING on page 28). This display will also show your heart rate when you use the handgrip pulse sensor or the optional chest pulse sensor. Note: The console can display speed and distance in either miles or kilometers. The letters "MPH" or "Km/H" will appear in the right display to show which unit of measurement is selected. To change the unit of measurement, see HOW TO USE THE INFORMATION MODE on page 21. For simplicity, all instructions in this section refer to miles. To reset the displays, press the Stop button, remove the key, and then reinsert the key. 6 Measure your heart rate if desired. Note: If you use the handgrip pulse sensor and the optional chest pulse sensor at the same time, the console will not display your heart rate accurately. Before using the handgrip pulse sensor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean. Contacts Next, hold the handgrip pulse sensor with your palms resting on the metal contacts; avoid moving your hands. When your pulse is detected, the heart-shaped indicator in the right display will flash each time your heart beats, one or two dashes (- -) will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 7 Turn on the fan if desired. To turn on the fan, press the Fan button. To turn on the fan at high speed, press the button a second time. To turn off the fan, press the button a third time. Note: If the fan is on when the walking belt is stopped, the fan will automatically turn off after a few minutes. 8 When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage position or the treadmill will become damaged. Next, remove the key from the console and put it in a secure place. Note: If the displays remain lit after the key is removed, the console is in the "demo" mode. See HOW TO USE THE INFORMATION MODE on page 21 and turn off the demo mode. When you are finished using the treadmill, switch the reset/off circuit breaker to the "off" position and unplug the power cord. When you are finished using the treadmill, switch the reset/off circuit breaker to the "off" position and unplug the power cord. IMPORTANT: If you do not do this, the treadmill's electrical components may wear prematurely. 14