Ricoh 3245 Printer Reference - Page 152

Appendix Problem Causes and Solutions When using Windows 95/98/Me/ 2000/XP, Windows Server 2003, or Windows NT 4.0, either combined printing or booklet print does not come out as expected. Make sure the application's paper size and orientation settings match those of the printer driver. If a different paper size and orientation are set, select the same size and orientation. When using Windows 95/98/Me/ 2000/XP, Windows Server 2003, or Windows NT 4.0, Auto Reduce/Enlarge print does not come out as expected. A print instruction was issued from the computer, but printing did not start. User code management may have been set. Ask the administrator about valid user codes. To print, the user code must be entered from the printer driver. The print job is not Even when the machine is offline, printing is performed when [Job Accept- canceled even ance Priority] has been set in [Parallel Interface] in the [Interface Settings] in the 8 when the machine System Settings menu. Change the setting of Signal Control to Printer priis switched to of- ority. fline status. See "User Tools (System Settings)", General Settings Guide. Photo images are Some applications reduce print resolution. coarse. Fine dot pattern does not print. Make the following settings with the printer driver: • Change the [Dithering:] setting on the [Image Adjustments] tab in the [Change User Settings...] dialog box on the [Print Quality] tab in the RPCS printer driver. Note ❒ To enable [Change User Settings...], select the [User Setting] check box. See the printer driver Help. Images are cut off, You may be using paper smaller than the size selected in the application. or excess is printed. Use the same size paper as that selected in the application. If you cannot load paper of the correct size, use the reduction function to reduce the image, and then print. See the printer driver Help. 146