Ricoh Aficio MP 1600 Network Guide - Page 81
wins, msh> wins, msh> wins interface_name, on | off}, primary|secondary} IP, address
View all Ricoh Aficio MP 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Remote Maintenance by telnet wins Use the "wins" command to configure WINS server settings. ❖ NBT (NetBIOS over TCP/IP) Scope ID Selection You can specify the NBT scope ID. msh> wins "interface_name" scope "scope ID" ❖ Viewing settings msh> wins • If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address is the valid address. ❖ Configuration msh> wins "interface_name" {on | off} • The scope ID can be entered us- ing up to 31 alphanumeric char- acters. 2 • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name ether Interface configured Ethernet interface • {on} means "active" and {off} wlan means "inactive". IEEE 802.11b interface • Be sure to specify the interface. • wlan can be specified only when the IEEE 802.11b interface is installed. Interface name Interface configured ether Ethernet interface wlan IEEE 802.11b interface ❖ Address configuration Use the following command to configure a WINS server IP address: msh> wins "interface_name" {primary|secondary} "IP address" • Use the "primary" command to configure a primary WINS server IP address. • Use the "secondary" command to configure a secondary WINS server IP address. • Do not use "255.255.255.255" as the IP address. 73