Ricoh P C200W Printer Languages and Interfaces Technical Reference - Page 21
PCL emulation commands by function macros, Font Control, Set Character Code, Load Character
View all Ricoh P C200W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Printer Control Language (PCL) emulation 21 Command / Parameters ESC*c#F 0-Delete all (temporary and permanent) 1-Delete all temporary 2-Delete previous font ID 3-Delete previous specified character 4-Make previous font ID temporary 5-Make previous font ID permanent 6-Copy current font ESC*c#E Where: # = code point (0-65536). 0 is the factory default value. ESC(s#W[data] Where: # = number of data bytes. Function / Result Font Control Manages soft fonts. Set Character Code Sets the decimal code point associated with the next character downloaded or deleted. Load Character Downloads character descriptor and data to the current character code. PCL emulation commands by function (macros) Command / Parameters Function / Result ESC&f#Y Set Macro ID Where: Sets the ID for the macro that is created on flash memory # = micro ID (0-32767). 0 is the factory default value. or hard disk. ESC&f#X 0-Start definition 1-End definition 2-Execute macro (previous macro ID) 3-Call macro (previous macro ID) 4-Enable overlay (previous macro ID) 5-Disable overlay 6-Delete all macros 7-Delete all temporary macros 8-Delete current macro ID 9-Make last ID temporary 10-Make last ID permanent Macro Control Manages the use of macros. For more information, see "Creating macros" on page 39. Notes: • GL/2 commands are supported inside macros. • Only call and execute macro commands are allowed within a macro. • A macro may call or execute another macro. This is called nesting. A maximum of two nesting levels are allowed, for a total of three levels.