Ridgid WD1680 Owners Manual - Page 26

SP6779-2 Ridgid WD1680 E S 2/3/12 1:57 PM Page 6 Drum/Caster Foot Assembly If any parts are missing or damaged contact Customer Service. Do not assemble until you have all the parts. 1. Insert the front and rear caster feet into the bottom of drum as shown. Light taps with a mallet or hammer may be needed to fully seat both caster feet. Front Caster Foot Drain Drum Rear Caster Foot 2. Install (4) #10 x 1-3/4" screws into matching holes on both front and rear caster feet, securing them to the bottom of the drum. Tighten screws until just snug. Do not over tighten as this may tend to deform the caster feet. #10 x 1-3/4" Screw (4) Drain Rear Caster Foot Front Caster Foot 3. Insert the caster stem into each of the caster feet, as shown. 4. Push on the caster until the ball on the caster stem is inserted all the way into the socket. You will be able to hear the ball snap into the socket and the caster will swivel easily when positioning is correct. Socket Caster Stem Caster Ball 6