Ridgid WD1680 Owners Manual - Page 29

SP6779-2 Ridgid WD1680 E S 2/3/12 1:57 PM Page 9 Positioning Detachable Blower (Power Head Assembly) 1. To remove the detachable blower from the lid assembly, press down on the detachable blower latch under the detachable blower handle and lift the blower off the lid of the Vac. Detachable Blower Latch Detachable Blower Handle 3. Lightly press down on the carry handle of the detachable blower until you hear the "snap" of the detachable blower latch engaging the detachable blower. The detachable blower is now latched to the lid assembly. Detachable Blower Detachable Blower Latch Detachable Blower Molded Leads 2. To replace the detachable blower onto the lid assembly, position detachable blower above the indented area of the lid assembly. Rotate the detachable blower down until the travel of the unit stops. 4. Your new Wet/Dry Vac is ready for use. With the Wet/Dry Vac completely assembled and ready for use, insert the push button end of the "DualFlex™ Locking" hose into the inlet of the Vac. The hose should snap into place. To remove the hose from the Vac, press the release button in the hose assembly and pull the hose out of the Vac inlet, as shown. Press and Pull Release Button 9