Ridgid WD1680 Owners Manual - Page 34

SP6779-2 Ridgid WD1680 E S 2/3/12 1:57 PM Page 14 Maintenance Detachable Blower Intake ! WARNING: To reduce the risk of injury from accidental starting, unplug power cord before changing or cleaning filter or foam pad. After using the detachable blower of your Wet/Dry Vac, examine the bottom of the blower for dust and debris. Check to see if the intake to the blower has debris stuck to the plastic vents and foam pad. To clean the foam pad under the intake shield of the detachable blower: 1. Remove the three screws holding the intake shield. 2. Lift the intake shield off and set aside. 3. Lift the foam pad away from the detachable blower. 4. Remove the foam pad and clean in warm soapy water or brush debris away. Allow foam pad to dry. 5. Examine foam pad for reuse. If you need to replace it, check the service part section of this manual. Foam Pad Intake Shield Screws (3) 6. Replace foam pad by reversing steps 1 thru 4. 7. Reinstall intake shield and 3 screws. The unit is ready for use. 14