Rocketfish RF-RBAUX User Manual (English) - Page 22

6 Press and hold the on the Rocketboost hub device for more than three seconds to put it into joining mode. The power indicator starts blinking rapidly and the unit will stay in joining mode for 30 seconds. The diagram (below) shows an example of this. In this example, the sender/receiver is the hub device. Power on indicator TM 7 Press and hold the on your other Rocketboost device for more than three seconds to put it into joining mode. • When successfully joined, the power indicator LEDs on both products will stop blinking and stay on. • If joining fails after 30 seconds, the power indicator LEDs will begin flashing at a slower rate. If this occurs, repeat the above steps. • Repeat steps 2-7 for each additional Rocketboost device you are adding to your network. Listening to music To listen to music: 1 Make sure the volume is turned up on the audio device connected to your Rocketboost sender. 2 Play music from the audio device connected to your Rocketboost sender. Note: When using the sender/receiver as a sender, the Tx LED will light when you are correctly connected to an audio source. 3 Adjust the volume level on the audio device you have connected to your Rocketboost receiver. If you have multiple audio sources in your Rocketboost network, press the Source button on the Rocketboost receiver to hear the next audio source. Press the Source button again to cycle through all available audio sources. Note: When using the sender/receiver as a receiver, the Rx LED will light when you are receiving an audio source from the Rocketboost network. 22