Rocketfish RF-WS01 User Manual (English) - Page 17
Maintaining your system, Troubleshooting - sender unit
View all Rocketfish RF-WS01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Maintaining your system Use a soft cloth dampened with a weak solution of mild detergent and water. Dry the apparatus immediately afterwards with a clean cloth. Do not use abrasive cloth, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering. Cautions: • Do not cover the ventilation openings with items, such as newspapers, table clothes, and curtains. • If the power cord is damaged, it must be repaired by a qualified repairer. Note: • If the RS-WS02 becomes wet, you can drain water by gently tipping it slightly to one side for a few seconds. Troubleshooting Read this User Guide carefully before using your digital wireless speakers. Check this list for a possible troubleshooting solution before calling for service. Problem No sound Solution • Make sure the sender AC adapter is connected to the sender, and either the speaker AC adapter is connected or fresh or charged batteries are installed in the speakers. • Make sure that all cables are connected correctly. Check to see if the green Link Status LEDs illuminate on the front of both the sender and speaker units. If the green Link Status LEDs are lit solidly, the communication is working correctly and the audio cables from audio source to the sender should be checked. If the green Link Status LEDs are flashing or off, refer to the "No communication between sender and speaker" section below. RF-WS01/WS01-W/WS02 17